The grid plate in the photo below is still laser cut. Now we will remove it with a chisel.




















Photo below: Use a chisel to cut the connected parts.




















I removed the photo below.




















As shown in the photo below, three boards are used for each unit. The board in the middle is shaped by hand into a round eel shape. All three boards are shaped in the same way.




















Counterclockwise from the top right in the photo below: base plate, pedestal, AC adapter, remote control, core pillar RGB LED driver, first observation deck white ring LED, second observation deck ring LED, 5V low voltage DC/DC converter, SW DC jack DC plug harness, second observation deck ring LED controller, first and second observation deck harness




















Lower photo: Close-up of harness




















Lower photo: Close-up of harness




















Lower photo: Close-up of harness




















The photo below shows the harnesses for the first and second observation decks being attached to the first observation deck.




















The photo below shows the harness for the first and second observation decks being attached to the second observation deck.





















Lower photo: Installation of the bottom wiring of the harness for the first and second observation decks




















Lower photo: White LED ring installed on the first observation deck




















Lower photo: Second observation deck ring LED installation connection




















Lower photo: After connecting the LED to the second observation deck, install the R12 disk




















Lower photo: First observation deck upper disc R2 installation and fixing




















Bottom photo: Second observation deck upper disc R2 installation and fixing completed




















Photo below: Installing the F8 board on the second observation deck




















The photo below shows the F9 board installed on the second observation deck, and the F8 board just above it.




















Photo below: Second observation deck F10 board installed